Changed: MBR will be preserved after a RAID mode change until the drives are formatted
Remarks
The firmware has to be updated when the device is connected via USB.
The firmware can not be updated if no drives are installed.
Warning
Never turn off your unit during the firmware update procedure. This may damage your device! If the upgrade fails (e.g. power supply failure during firmware update), you may not be able to operate your device anymore.
This firmware is only for inXtron's standard products and specifically the model(s) as mentioned above. DO NOT use this firmware for any other devices!
How to update the firmware
Download the latest firmware and save it on
your local disk.
Turn on the Hydra Super-S Combo and connect it to your computer via USB.
On the Mac, open the *.dmg file to mount the folder and then double-click on the "Setup" file to start the updater utility.
On the PC, unzip the downloaded file and double-click on the
*.exe file to start the updater utility.
Click on the "Upgrade" button to start the firmware update.
Wait for the update process to finish and make sure to never turn off the power during the firmware update procedure!
When the upgrade is finished, click on the "Exit" button to close the program. After the firmware update, the system will restart by itself to load the new firmware, so the device will be disconnected and mounted again.
